| Door Cords |
|
| An inexpensive method of transferring up to 8 wires where aesthetics and vandalism are not great concerns. Features stainless steel armored cable. For use on hollow metal or aluminum doors. |
| DC1-18 |
18”Loop; Stainless Steel Cable |
| DC1-24 |
24” Loop; Stainless Steel Cable |
| |
Available in Aluminum (A) or Duronodic (D) finish |
| |
|
 |
Door cord
The wires are connected and covered under the cap |
|
| Panic Bar Retrofit Cords |
|
| An armored cable to be installed below the panic bar when adding a LEXITM trim to an existing bar. Package includes wire, mounting clips for under bar and steel clips for mounting to the frame. |
| PTC-48 |
For doors up to 36”; Stainless Steel Cable |
| PTC-60 |
For doors up to 48”; Stainless Steel Cable |
| |
|
 |
| Cable provided to reach across door, create loop, and mount on frame |
|
| Electric Mini-Hinges |
|
| Geared continuous hinges are used on high-traffic doors. Geared mini-hinges may be added to existing doors when electrified trim is used. The entire hinge need not be replaced. The top 1-1/2” is removed and the minihinge installed in its place. Mini-hinges are much friendlier to installers than full-length electrified hinges. A serviceman can check connections without removing the entire door when a mini-hinge is used. |
| ECHFM-R |
Mortise; Matches Roton 780-112 (avail. w/ 4 or 6 wires) |
| ECHFM-Z |
Mortise; Matches Zero 910 (available with 4 or 6 wires) |
| ECHFS-R |
Surface; Matches Roton 780-157 (4 wires) |
| ECHFS-Z |
Surface; Matches Zero 935 (4 wires) |
| ECHHS-R |
Surface; Matches Roton 780-054 (4 wires) |
| ECHHS-Z |
Surface; Matches Zero 920 (4 wires) |
| |
Available in Aluminum (A) or Duronodic (D) finish |
| |
|
 |
| Geared hinge manufacturers do not share common sizes. Please identify mfr. and model when ordering. |
|
| Electrified Hinges |
|
| The cleanest method of transferring power from the frame where the door is hung by hinges. Recommended for new construction or retrofit into frames without concrete. Available in 4, 6, 8 or 10 wire models. See price list for available sizes. Optional door position switch provides valuable information to access control system. |
| EH4040-626-4 |
4 wires, 4” tall, 4” wide; Satin Chrome Finish |
| EH4540-626-4 |
4 wires, 4.5” tall, 4” wide; Satin Chrome Finish |
| EH4545-626-4 |
4 wires, 4.5” tall, 4.5” wide; Satin Chrome Finish |
| EH5045-626-4 |
4 wires, 5” tall, 4.5” wide; Satin Chrome Finish |
| EH5050-626-4 |
4 wires, 5” tall, 5” wide; Satin Chrome Finish |
| |
|
 |
| An electrified hinge must match the existing hinge. Determine the height. Determine the open width by measuring across the two leafs and knuckle when open. |
|
| TransXTM |
|
| TransXTM connects multiple wires from the door to the frame in a concealed, protected manner. Trim wires run through the door into the TransXTM door module (the lower box). The wire passes from the frame module to the bottom side of the terminal strip. Access control technicians or electricians bring their low voltage wires through conduit into the TransXTM frame module and connect to the upper side of the terminal strip. |
| PTB-106-(hand) |
6 Terminal Strips; Mounts On Pull Side Of Door, Designate LH or RH |
| PTB-110-(hand) |
10 Terminal Strips; Mounts On Pull Side Of Door, Designate LH or RH |
 TransX is mounting on the pull side of the door. To designate handing stand on the interior side of the door, check if the hinges are on the right or the left. |
| |
|
 |
| YAMAKATM |
|
| An innovative method for hollow metal, aluminum (YMK-20) or wood doors (YMK-21). The module (A.) mounts in the top of the door, with the spring loaded tips protruding above the door. As the door closes, the tips make contact with the transfer plate (B.) which is mounted to the frame. Tested for 1 million cycles. Not for Fail-Safe applications. |
| YMK-20 |
Mounts on top of door, flat plate onto header, for hollow metal or aluminum doors |
| YMK-21 |
Mounts in frame, flat plate on door, for wood doors |
| |
|
 |
