| |
| |
Top
Trigger Models |
| |
A
special top trigger (in place of the trigger
below the horizontal deadbolt) is available
for use on doors with multi-point locking
and the serface-bolt option which are
openly exposed to the general public and
where there is a high likelihood of mis-use
(such as rear exit doors in public housing).
8200V Series (used on pairs of doors)
do not require a center mullion. |
|
|
| |
Cylinder
Dogging |
 |
The
interior lever is locked in the downward
position which keeps the latch retracted.
The door can then be pushed or pulled
open. The lever is released and the door
re-locked by use of key. Exiting is possible
at all times, regardless of mode. |
|
|
|
| |
| Electric
Release Options |
| |
24vAC,
30va transformer required |
| |
24vDC
transformer required |
| |
24vDC,
Fail-Safe Re-Entry Function |
|
|
| Latch
Position Switch
Latch position
switch for use with alarms |
|
| Key
Usage Signal Switch
For use with
access control systems. Sends a signal to the
access control system that a key (not card)
was used for entry. |
|
|
Access
Control Cut-Off Switch
Access control
systems can be complicated to program and turn
on and off. Frequently a computer is needed
to change status, time zones, etc. The cut-off
switch feature allows a clockwise rotation of
the key to toggle the access control system
on or off. The supervisor does not need to have
any programming skills to turn the system off
for a defined period (after hours, weekend,
etc.) or turn it back on. |
|
|
| Classroom
Function
Key unlocks lever
for extended period, until key is used to re-lock
lever. Lock functions in passage mode while
exterior lever is in unlocked mode. |
|
|
| R-T-E
Switch
Optional signal
switch for interior trim for use with alarmed
or access control doors. Deprressing the interior
lever actuates the switch. |
|
|
Cylinder
Protector
(UG Trim Only) |
| |
Full
face steel cylinder protector is standard
for regular cylinders |
|
|
|
"BEST"-
type IC core cylinders require a 8"
plug opening |
|
|
|
Yale IC core cylinders require an oval
keyhole opening |
|
|
|
|
| 8
' Lead Length
Eliminates wiring
connections in the lock area of the door |
| Vertical
Deadbolt Control
See Separate
Catalog Cut |
|
| EDGE
PLATES
| Doors
which have inverted U-channels do not
require special edge preparations, |
| as
they will use the elevated |
|
|
edge plate which fits into the channel.
A flat edge plate is available for wood
doors or flush HM doors. |
|
|
| VANDAL
RESISTANCE
| |
| Hardened
steel cylinder protectors on both
units. |
|
|
"Slip-Clutch"
Lever Handle:
Standard with UG & GG
Lever will "breakaway" if forced,
but does not unlock door. Lever can be
simply reset by lifting back to original
(horizontal) position. |
|
"Slip-Off"
Pull Handle:
Spoils attempts to rip the door from the
frame by tying a chain to the lever and
pulling with a car. Pull handle will separate
from guard plate if forced. |
|
|
| Requirements
| • |
Min.
1-3/4" door thickness |
| • |
4-7/8"
frame strike prep |
| • |
1-1/4"
x 8" door mortise prep |
| • |
Vertically-stiffened
hollow-metal door (For internally mounted
multi-point locks |
|
|
|
| |
| |
