|
|
| |
| Maglatch
Wiring Scenarios |
|
|
|
1
|
Power
Supply |
|
2
|
Power
Transfer Device |
|
3
|
Electrically
Released Lever Trim |
|
4
|
Access
Control Reader/Controller |
|
| If
access control system can output 24vDC,
Securitech power supply is not required. |
|
|
|
|
1
|
Power
Supply |
|
2
|
Power
Transfer Device |
|
3
|
Electrically
Released Lever Trim |
|
4
|
Access
Control Reader/Controller |
|
| The
Fire Alarm Panel circuit will immediately
cut-power to meet lifesafety and Re-Entry
code requirements. |
|
|
|
| The magnet
is installed in the frame. One power line
goes direct, the other through the lever
trim switches. |
|
|
1
|
Power
Supply |
|
2
|
Power
Transfer Device |
|
3
|
Interior
Level Trim & Electrically Released Lever
Trim x EML Cutoff Switch |
|
4
|
Electromagnetic
Lock x 24vDC |
|
|
If
intercom output is a dry contact, use power supply
PS107A. |
|
|
|
Power
Supplied By Access Control System
|
Most access control
systems can output 24vDC. Therefore, a Securitech
power supply is not required in Electrolatch "DC"
applications and Electrolatch Signal Lock applications. |
|
1
|
Access
Control Power Supply |
|
2
|
Power
Transfer Device |
|
3
|
Interior
Trim with Switch
Exterior Trim with Electric Release |
|
4
|
Access
Control Reader |
|
|
|
|
|
Full
elevations and point-to-point wiring diagrams are available
for all Securitech Control Trim, Signal Lock, Entry &
Exit Control Systems and single door power supplies.
Contact the factory with your requirements. |
|
