Untitled Document

Maglatch Wiring Scenarios

Standard Electrolatch

PS 91

1	Power Supply
2	Power Transfer Device
3	Electrically Released Lever Trim
4	Access Control Reader/Controller

If access control system can output 24vDC, Securittech power supply is not required.

Electrolatch Re-Entry

PS 91-RE

1	Power Supply
2	Power Transfer Device
3	Electrically Released Lever Trim
4	Access Control Reader/Controller

The Fire Alarm Panel circuit will immediately cut-power to meet lifesafety and Re-Entry code requirements.

Standard Maglatch

PS 105

The magnet is installed in the frame. One power line goes direct, the other through the lever trim switches.

1	Power Supply
2	Power Transfer Device
3	Interior Level Trim & Electrically Released Lever Trim x EML Cutoff Switch
4	Electromagnetic Lock x 24vDC

If intercom output is a dry contact, use power supply PS107A.

Electrolatch Signal Lock

Power Supplied By Access Control System

Most access control systems can output 24vDC. Therefore, a Securitech power supply is not required in Electrolatch "DC" applications and Electrolatch Signal Lock applications.

1	Access Control Power Supply
2	Power Transfer Device
3	Interior Trim with Switch Exterior Trim with Electric Release
4	Access Control Reader

Full elevations and point-to-point wiring diagrams are available for all Securitech Control Trim, Signal Lock, Entry & Exit Control Systems and single door power supplies.

Contact the factory with your requirements.